Method used to configure services on the TN52TOM board

1

The procedure for configuring services on the TN52TOM board is as follows:
1. Configure the working mode of the TN52TOM board and the working mode of its ports.
2. Set the service type of its LP port.
3. Create a service from a physical port to an LP port.
4. Create a service from its LP port to a line board.

Other related questions:
Method used to determine whether the TN52TOM board properly transmits internal services
The Ethernet maintenance function provided by the TOM board can be used to determine whether the TOM board properly sends internal services based on the sent and received test frames.

Method used to configure services on an LOA board
There are three methods of configuring services on the LOA board: 1. By site manually 2. Using service packages for the LOA board 3. By trail

Entry for setting the client-side service type for the LDGF and TN52TOM boards
You can set the client-side service types for LDGF and TN52TOM boards in WDM Interface in the NE Explorer on the NMS.

Method used to interconnect services on the TDX board and NS2 board
Cross-connections are configured between the two boards to groom services in between.

Power consumption of the TN52TOM board
The typical power consumption and maximum power consumption of the TN52TOM board are 81 W and 89.1 W respectively. The maximum power consumption refers to the power consumed by the board when it works normally under the highest ambient temperature.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top