Function of automatically shutting down the client-side laser of a board

17

If this function is enabled, the client-side laser of a board will be automatically shut down when the WDM side of the board receives no optical signal.

Other related questions:
Method used to shut down a board laser
Select the desired board in the NE Explorer. Choose Configuration > WDM Interface from the navigation tree. Select By Board/Port(Channel) and choose Channel from the drop-down list. On the Basic Attributes tab, double-click Laser Status of the desired optical port, and then select Enable or Disable from the drop-down list to change the laser status.

Shutting down the firewall
The firewall does not support power-off through the CLI or automatic power-off. Instead, you need to press a button to power it off.

The TE Mobile is automatically deregistered after being shut down
The TE Mobile is automatically deregistered after being shut down. After the TE Mobile is shut down, it goes offline only from the SC. If the TE Mobile is started again, it can still be used. Different from the VC100, the TE Mobile does not have an activated software license. In this case, the TE Mobile is similar to other apps on mobile phones.

Whether the TOM board on the OSN 6800 supports 1.25G optical modules and whether the client-side laser on the local board emits light if no light is received on the client side of the peer board
The client side of a TOM board supports optical modules with rates ranging from 100 Mbit/s to 2.5 Gbit/s. When ALS is enabled for the client-side laser on the local TOM board, the client-side laser on the local board will not emit light if no light is received on the client side of the peer board. When ALS is disabled for the client-side laser on the local TOM board, the status of the client-side laser on the local board is not adversely affected by the client-side light receiving status of the peer board.

Command used to set the Automatic Laser Shutdown function for a laser on BWS 320G
To set the Automatic Laser Shutdown function for a laser on BWS 320G, run the following command: cfg-set-lasautosd:bid,path,flag To query the Automatic Laser Shutdown function for a laser on BWS 320G, run the following command: cfg-get-lasautosd:bid,path

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat