Method used to query intra-site fiber connections on the NMS

3

On the main topology, you can double-click the target NE and click the Signal Flow Diagram tab to view the intra-site fiber connections.

Other related questions:
Method used to query intra-NE fiber connections on the NMS
You can query the logical fiber connections between optical NEs in the main view of the U2000. On the main topology of the U2000, double-click the desired optical NE to display the status diagrams of the NE. Select the signal flow diagram. Then you can query the logical fiber connections between boards of the optical NE.

Whether there are special pigtail requirements of intra-site fiber connections on the OSN 6800
There are no special pigtail requirements except that the pigtails must be clean and free of any visual damage.

Method used to connect NMS computers
You can connect them directly or over a LAN.

Methods for querying and deleting logical fiber connections on an OptiX OSN 6800 board by using commands
Command for querying: :cfg-get-fibermgr:SrcNeid,SrcBid,DstNeid,DstBid. Command for deleting: :cfg-del-fibermgr:SrcNeid,SrcBid,SrcPort,DstNeid,DstBid,DstPort.

Method used to verify the consistency between physical fiber connections and logical fiber connections on Metro 1000
1. The Metro 1000 V2 does not support query for received J0 bytes. You can change the number of J0 bytes to be transmitted at the local end to be different from the number of J0 bytes to be received at the peer end, and then check whether the J0_MM alarm is reported. 2. You can also insert an MS_AIS alarm and check whether the peer end reports the MS_AIS alarm. Exercise caution because this operation will interrupt services.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top