Whether an OptiX OSN 8800 subrack can function as a slave subrack of an OptiX OSN 6800 subrack

At present, packet boards can be used only in an independent subrack, but not in the master or slave subrack when subracks are configured in the master-slave mode. When packet boards are configured in an OptiX OSN 8800 T32 subrack, the cross-connect board must be TN52UXCH or TN52UXCM, and the system control board must be TN52SCC in the subrack. When packet boards are configured in an OptiX OSN 8800 T16 subrack, the cross-connect board must be TN16UXCM in the subrack.

Run the :cfg-add-shelf:1,shelf6800 command to add a slave subrack.

The power consumption of a fully configured OptiX OSN 8800 T16 subrack is 1800 W, the maximum current is 50 A, and the circuit breaker on the PDU is 63 A.

If the newly installed subrack is configured as the slave subrack, connect the ETH port on the EFI board of the subrack to the ETH port on the EFI board of the existing subrack. If the newly installed subrack is configured as the master subrack, use extended ECC or SC2 for communication.

12ND2 can be housed only in an OptiX OSN 8800 universal platform subrack, or an OptiX OSN 6800 subrack.