Homepage FAQ Transport&Access Network

Method used to configure services on an LOA board

130

There are three methods of configuring services on the LOA board:
1. By site manually
2. Using service packages for the LOA board
3. By trail

Other related questions:

Whether the LOA board can receive FC100/FC200 multi-mode services

The LOA board can receive FC100/FC200 multi-mode services using I-16-2km modules, which have been specified in the board performance indicators.

FC services that are supported by the LOA board

The LOA board supports the following FC services: FC100: SAN service at a rate of 1.06 Gbit/s FC200: SAN service at a rate of 2.12 Gbit/s FC400: SAN service at a rate of 4.25 Gbit/s FC800: SAN service at a rate of 8.5 Gbit/s FC1200: SAN service at a rate of 10.51 Gbit/s

Method used to interconnect services on the TDX board and NS2 board

Cross-connections are configured between the two boards to groom services in between.

Method used to configure services on the TN52TOM board

The procedure for configuring services on the TN52TOM board is as follows: 1. Configure the working mode of the TN52TOM board and the working mode of its ports. 2. Set the service type of its LP port. 3. Create a service from a physical port to an LP port. 4. Create a service from its LP port to a line board.

LOA board configuration

The LOA board can be applied in five scenarios depending on the port working mode. You need to manually configure each application scenario on the NMS on a per-NE basis.

If you have more questions, you can seek help from following ways:

To WeiKnow To Live Chat

Enterprise

Consumer

Corporate

Carriers

Method used to configure services on an LOA board

Other related questions:

If you have more questions, you can seek help from following ways: