Method used to handle the error message indicating a mismatch between the working channel overhead setting and protection group layer (error code: 41907) during SNCP configuration on the OSN 6800

18

Verify that the non-intrusive monitoring at the PM layer of the line board is enabled.

Other related questions:
Reason for the overhead settings for the working channel of an ODUk SNCP protection group mismatch the protection group layer settings
During ODUk SNCP protection configuration, OTN overhead is configured based on the selected protection subtype. If overhead is incorrectly configured, the mismatch issue will occur.

Method used to handle the error message indicating a service conflict during service configuration on the OSN 8800
Delete discrete services.

Method used to handle the error message displayed indicating a mismatch between the cross-connect board and service board during logical board addition for the TOM board (error code 44061)
If the TOM board is a TN11TOM board, it cannot be used on the OSN 8800. You are advised to replace it with a TN52TOM board.

Method used to handle the error message displayed indicating a mismatch between the created service board and the existing service board during logical board addition for the TOA board (error code 44062)
Verify that cross-connect boards are configured.

Method used to handle the error message (error code 38754) displayed upon a failure to query the OLP status on the port protection window
This issue is caused by a board hardware fault. When this occurs, replace the board.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top