Common causes of card registration failures and corresponding solutions

18

1. Check whether the card is present.
Run the display device command. In the displayed output information, check whether the value of the Online field of the slot in which the card is installed is Present. If the value of the Online field is not Present, the card is not present. Install the card again or in another slot.
2. Confirm whether the version of the device supports the card.
Run the display elabel command. In the displayed output information, check the BOM field of the slot in which the card is installed to obtain the BOM code of the card. Confirm whether the version of the device supports the card based on the BOM code of the card. If the version of the device does not support the card, update the version of the device.
3. If the card still fails to be registered after the preceding procedures are performed, contact Huawei engineers.

Other related questions:
Why a PoE card fails to be registered on S series switches
The ES0D0G48VA00 card is the PoE card for the S12700 and S7700, and the LE0DG48VEA00 card is the PoE card for the S9300. Possible causes of a PoE card registration failure are as follows: No PoE power module is installed in the PoE power slot of the switch. The PoE power module is not powered on. The dual in-line memory module (DIMM) is faulty. For the handling methods, see "Fault Locating Guide - Card Registration Failure" in Huawei S Series Campus Switches Maintenance Guide.

What are the common causes of the failure to initiate a SiteCall?
Common causes of the failure to initiate a SiteCall: An endpoint can initiate a SiteCall only after registering with the GK server through the allocated account and password. Log in to the web interface, choose System > Admin > Call > H.323, and set the following parameters: Register on GK: Select Enable. GK IP: Enter the GK/SC address. (The management platform can be the MCU's built-in web interface or SMC1.0/2.0.) Site number: Enter the site ID allocated by the platform. User name: The value must be the same as that specified on the management platform. Password: The value must be the same as that specified on the management platform. HUAWEI GK: Select Enable.

Mobile prompt VOIP registration failed
Mobile Prompt VOIP Registration Failed,It May Be Turned On The Phone's Limit Power Saving Mode, Resulting In Turn Off VOIP Function

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top