Large cards cannot be installed on AR1200 series routers

1

AR1200 series routers support slot combination. You can remove the guide rail between two slots to install larger cards.

Other related questions:
An AR router cannot discover the E1 card
The E1 card of the AR router is not registered. 1. Check whether the card is still in the startup process. - The startup time of an SRU is within 3 minutes. In scenarios where the card is restarted after the system software is updated, the startup time of the card is within 5 minutes. - The startup time of an interface card is within 5 minutes. In scenarios where the system software needs to be updated, the startup time of the card is within 10 minutes. 2. If a card does not start up within the normal startup time, run the display device command to check the status of the card. - If the status of the card displayed under the Register field of the displayed output information is Unregistered, the card is not registered. In this case, check whether the card is reset. - Run the display reset-reason [ slot slot-id ] command in the diagnosis view. a. If no reset information about the card is displayed, the card has never been registered. In this case, pull out the card and insert it again. b. If reset causes of the card are displayed, resolve the reset problems of the card based on the displayed causes.

Method used to cancel automatic configuration of AR1200 series routers
Analysis: When ARG3 series products log in to the console interface for the first time or the configuration file is not enabled, the massage “Warning: Auto-Config is working. Do you want to stop Auto-Config? [y/n]:”is displayed. Auto-Config is working. Do you want to stop Auto-Config? When n is selected, Auto-Config function cannot be automatically restored and you need to manually stop the Auto-Config process.Recommended solution: View the configuration and operation status of Auto-Config.When the automatic configuration is running, you need to run the undo autoconfig enable command to disable automatic configuration in the system view.

Card installation and replacement on S series switches
For card installation and replacement of switches, see the Hardware Installation and Maintenance Guide. For the S9300 and S9300E, see S9300&S9300E Hardware Installation and Maintenance Guide. For the S7700 and S9700, see S7700&S9700 Hardware Installation and Maintenance Guide. For the S12700, see S12700 Hardware Installation and Maintenance Guide.

What are the differences between the two Micro SD cards installed on AR2200 and AR3200 series routers
Solution: AR2200 and AR3200 series support two Micro SD cards, in which the built-in Micro SD card is named sd1, and the Micro SD card installed by the user is named sd0. The functions of the two Micro SD cards are same except that logs generated by the device are stored on sd1 by default.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top