Difference between the operation mode and transparent mode in processing overheads

0

The operation mode and transparent mode differ in the generation of TCM overheads. To be specific, TCM overheads are re-generated in operation mode but not re-generated in transparent mode.

Other related questions:
Difference between the subcard mode and board mode
The subboard mode refers to the current working mode of a subboard. The board mode refers to the current working mode of a board. Different types of boards and subboards support different types of working modes. Many commands are used to switch the subboard mode and board mode. These commands start with set service-mode. To set the subboard mode, you can run the set service-mode card or set service-mode slot card command in the system view. To set the board mode, you can run the set service-mode slot command in the system view.

Difference between cascading mode and non-cascading mode
TOM boards can work in cascading or non-cascading mode. In cascading mode, the total client-side service rate for each TOM board must be less than or equal to 2.5 Gbit/s. In non-cascading mode, the total client-side service rate for each TOM board must be less than or equal to 10 Gbit/s. When working in cascading mode, each TOM board can map a maximum of eight client-side services into one ODU0 or ODU1 signal. When working in non-cascading mode, it can map a maximum of four client-side services into one ODU0 or ODU1 signal. To map more than four client-side services into one ODU1 or ODU0 signal, the cascading mode is recommended. To map four or less client-side services into one ODU1 or ODU0 signal, the non-cascading mode is recommended.

What is the difference between the BPDU packet transparent transmission modes of the bridges on AR routers in different forms

Difference between the BPDU packet transparent transmission modes of the bridges on AR routers in different forms:
The bridges on AR routers in all forms do not transparently transmit BPDU packets. Therefore, there is no difference.

What are the differences between AP restart modes and what are their application scenarios
You can restart an AP in the following ways: run the reset command on the AC, log in to the AP and restart it, hold down the RESET button on the AP, and power off and on the AP. The differences and application scenarios of these restart modes are as follows: - Run the reset command on the AC: Run the ap-reset { all | id ap-id | ap-type { type ap-type | type-id type-id } } command in the WLAN view to restart a specified AP or APs in batches. This command applies only to online APs. - Log in to the AP and restart it: Log in to the AP and run the reboot command in the user view to restart the AP. You can restart an AP using this method only after you log in to the AP using Telnet or through the console port. This method is used to restart APs that are not online on the AC. You can connect a PC to the wired interface of the AP and log in to the AP using Telnet. - Hold down the RESET button on the AP: Using this method, you can restart an AP without the need to get the AP online or log in to the AP. - Power off and on the AP: If the AP uses PoE power supply, run the undo poe enable and poe enable commands in the interface view of the power sourcing equipment (PSE) to restart the AP.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top