Method for manually configuring cross-connections for port protection if dual feeding and selective receiving is configured on the WDM side


Dual feeding and selective receiving is implemented by cross-connections on the TOM board and intra-board 1+1 protection on the WDM side.

Other related questions:
Whether the USG9000 series supports cross-board port mirroring
The USG9000 series does not support cross-board port mirroring.

Whether dual feeding and selective receiving SNCP can be configured for all services on OSN 8800
When OTN services are groomed on OSN 8800, SNCP protection can be configured for all services, without any limitations.

Access rate of a WDM-side port on the TMX board
The WDM-side signals of the TMX board are OTU2 signals, and the access rate is 10.71 Gbit/s.

Maximum access rate of the TN52TOM board when the board works in tributary-line non-cascading mode and the dual-feeding and selective receiving function is enabled on the WDM side
In this scenario, three encapsulation paths are available for the TN52TOM board: Any->ODU0->ODU1->OTU1 OTU1->ODU1->Any->ODU0->ODU1->OTU1 OTU1/Any->ODU1->OTU1 The maximum access rates are 5 Gbit/s for all the three encapsulation paths.

Cause why the LTX board can be selected during cross-connection configuration
The mapping inside the LTX board is fixed, and therefore no cross-connection needs to be configured.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top