UPM monitoring for OSN 8800 on the NMS

7

UPM monitoring for OSN 8800 cannot be performed using the NMS.

Other related questions:
NMS monitoring port of OSN 8800
The NM-ETH port of an OSN 8800 device is the NMS monitoring port, which uses a crossover or straight-through network cable.

Names of management network ports on an OSN 8800
The NM-ETH port of an OSN 8800 is the NMS monitoring port, which uses crossover network cables.

NMS monitoring for multiple OSN 1800 devices at the same site
All NEs at a site can be set to gateway NEs. Three inter-NE communication modes are supported: Manual extended ECC mode: In this mode, extended ECC can be performed between OSN 1800 devices or between an OSN 1800 device and another OTN or SDH device in the same equipment room. OSC mode for RM/TM port interconnection Master/Slave subrack mode

Whether OptiX OSN 3500 and OptiX OSN 8800 can be managed by the same NMS
Yes. They can be managed using the T2000 or U2000.

Whether OSN 8800 supports the pre-configuration function on the NMS
All OTN equipment including OSN 8800 does not support pre-configuration on the NMS.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top