Whether services need to be configured on ELOG and LOG boards to enable links

1

Services do not need to be configured on the E8ELOG board. GE services need to be configured on E1/E3ELOG and LOG boards.

Other related questions:
Whether services need to be configured on the ELOG or LOG board before the circuit is enabled
Before the circuit is enabled, no service needs to be configured on the E8ELOG board, but GE services need to be configured on the E1/E3ELOG and LOG boards.

Can AR router send the NAT translation table to the log server?
The configuration of NAT Elog does not need to enable firewall function, configuration is as follows: Nat log-format eLog Firewall log session enable Firewall log session NAT enable Info-center source channel 2 log level FW-DEBUG notification Then is the normal configuration of info-center. Refer to the product manual configuration: configure NAT log output

Whether PM non-intrusive monitoring needs to be enabled for SNC/N services
Yes, PM non-intrusive monitoring needs to be enabled for SNC/N services. This configuration is automatically completed on the NMS and no manual operation is required in a version later than V100R006C01.

Which Users May Require CTS?

Users who need to perform the following operations may require CTS:

  • Security analysis
  • Fault locating
  • Tracking of resource changes

Do I need to enable STP after an Eth-Trunk is configured on S series switches
You do not need to configure STP after an Eth-Trunk is configured on S series switches (except the S1700).

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top