Network cable used on the management network port between devices for extended ECC communication

4

The Metro 2050 is connected to the OSN 1500B through the management network port using a crossover network cable for extended ECC communication, because both are terminal devices and Metro 2050 does not support auto-sensing.

Other related questions:
Method used to configure extended ECC in a slave subrack and method used to connect network cables to achieve extended ECC communication
The NM_ETH port of a slave subrack is disabled by default and is not used for inter-NE communication. Inter-NE communication is implemented only through the NM_ETH port of a master subrack.

Can I use the network port of an HD-VI to DVI+RJ45 cable to extend the control cable of the VPC600?
An HD-VI to DVI+RJ45 cable is a conversion cable used on an endpoint. To extend the control cable of a camera, use a VISC to RJ45 conversion cable through the COM IN port.

Differences between manually extended ECC and automatically extended ECC
1. In terms of functionality, there is no difference between manually extended ECC and automatically extended ECC. Automatically extended ECC is used by default. 2. Manually extended ECC is recommended when there are more than four NEs.

Whether an OSN 1800 can communicate with an SDH device through the extended ECC
An OSN 1800 can communicate with an SDH device through the extended ECC.

Whether OSN 1800 can be interconnected with SDH devices through the extended ECC
OSN 1800 can be interconnected with SDH devices through the extended ECC.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top