Function of the Ethernet port on the system control board of Metro 1000


The Ethernet port on the Metro 1000 is adaptive to RJ-45 connectors and is used for NMS access management. The port rate is 10 Mbit/s or 100 Mbit/s.

Other related questions:
Metro 1000 ethernet card function and fearture
1. ET1/ET1O/ET1D/EF1 card provide 10M/100M ethernet service ,support several different service type,implement ethernet over sdh function. ET1:8*10M/100M ethernet electrical interface card �?ET1D:2*10M/100M ethernet electrical interface card�?EF1:4*10M/100M以ethernet electrical interface card and 2*100Meth ernet optcial interface card�?2.EFS/EFSC/EGS :provide 10M/100M/1000M ethernet service, support EPL、EVPL(Ethernet Virtual Private Line)、EPLAN、EVPLAN(Ethernet Virtual Private LAN�?,implement ethernet over sdh function. EFT/ELT2/EGT card proivde 10M/100M/1000M ethernet service,support EPL service type. EFS/EFSC/EGS card use GFP(Generic Framing Procedure)protocol encapsulation. EFT/ELT2/EGT support GFP、LAPS(Link Access Procedure-SDH)、HDLC(High Level Data Link Control�?encapsulation .Mapping granule is vc12 or vc3. 3. EFS/EFSC/EGS/EFT/ELT2/EGT provide Inloop for fast locate faulty and troubleshooting and provide frame flow statistic, report and alarm funtion also support ALS

If ethernet card of metro1000 support transparent transmit vlan
EFT card support transparent transmit vlan and EFS need to disable incoming port vlan detect .

METRO 1000 SLOT capacity
Slot 1,slot 2,slot 3 provide 1.25G capcity respective ,slot 4 provide 622M

Whether fans for Metro 1000 V2 and Metro 1000 V3 are mutually universal
Yes, fans for Metro 1000 V2 and Metro 1000 V3 are mutually universal.

Command for setting alarm output of Metro 1000
The command for setting alarm output is as follows: :cfg-set-swoutmode:Bid, SwitchId, Switchmode, Example: cfg-set-swoutused:14,1,enable\\Indicates that alarm output is enabled.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top