Whether the FE08 board for the Metro 5000 can be interconnected with the EFS board for OSN equipment

12

The FE08 board uses the HDLC protocol for encapsulation. The EGS and EFS boards use the GFP protocol for encapsulation. Therefore, the FE08 board cannot interconnect with the EGS and EFS boards.

Other related questions:
Whether an ST2 board and SC2 board can be interconnected on an OSN 6800
It is not recommended that ST2 and SC2 boards be interconnected because they have different rates and encoding formats (CIM used by the SC2 board and FEC used by the ST2 board). SC1 and SC2 boards use the same rate and encoding format, and therefore can be interconnected.

Whether the ST2 board and the SC2 board can be interconnected on OptiX OSN 6800
It is not recommended that the ST2 and SC2 boards be interconnected because they have different rates and encoding formats (CIM used by the SC2 board and FEC used by the ST2 board). The SC1 and SC2 boards use the same rate and encoding format and therefore can be interconnected.

Whether services can be provisioned between EFS and ET1 boards
EFS and ET1 boards use different encapsulation protocols. Therefore, services cannot be provisioned between them.

Whether the EXCS boards for Metro 3000 can be replaced by XCS boards
You cannot replace only one EXCS board with one XCS board. Instead, you must use two XCS boards to replace both the active and standby EXCS boards.

Whether the TDX board on the OSN 8800 can be interconnected with the SL64 board on an NG SDH NE
Yes, the two boards can be interconnected through STM-64 optical ports.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top