Whether support SLD16 card by OSN7500

97

OSN7500 didn't support SLD16 card

Other related questions:
Whether the USG6000 supports the CF card
Yes.

Whether cards of S series fixed switches support copper modules
The following cards of S series fixed switches support GE copper modules: - ES5D000G4S01 cards (Applicable to S5700-EI series switches. After a GE copper module is installed, the link can go Up. However, you cannot run corresponding commands to configure the rate, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test on the link.) - ES5D00G4SA01 cards (Applicable to S5700-SI and S5710-LI series switches. After a GE copper module is installed, the link can go Up. However, you cannot run corresponding commands to configure the rate, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test on the link.) - ES5D00G4SC00 cards (Applicable to S5700-HI series switches. After a GE copper module is installed, the link can go Up. However, you cannot run corresponding commands to configure the rate, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test on the link.) - ES5D000X2S00 and ES5D000X4S01 cards (Supported by V200R002C00 and later versions, and applicable to S5700-SI series switches.) - ES5D00X2SA00 and ES5D00X4SA00 cards (Supported by V200R002C00 and later versions, and applicable to S5700-HI series switches.) - ES5D21X02S00 cards (Supported by V200R002C00 and later versions, and applicable to S5700-EI series switches.) You can use Hardware Query Tool to query the module types supported by specified cards.

Cards supported by S series fixed switches
The following S series fixed switches support cards: S3700-HI, S5710-C-LI, S5700-SI (except the S5700-26X-SI-12S-AC), S5700-EI, S5710-EI, S5720-C-EI, S5720-PC-EI, S5700-HI, S5710-HI, S5720-HI, and S6720-EI series switches. Cards must be installed on corresponding switches based on the mapping between them. If a card is installed on an incompatible switch, the card cannot register. You can use Hardware Query Tool to query the card models supported by specified switches.

Cards on S series modular switches that support service port clustering
The page on the right describes the cards that support service port clustering for S series modular switches.

Cross connection card capacity of OSN7500
GXCSA high order :240Gbit/s GXCSA low order :40Gbit/s GXCSA access capacity :200Gbit/s EXCSA high order :240Gbit/s EXCSA low order :40Gbit/s EXCSA access capacity :200Gbit/s UXCSA high order :360Gbit/s UXCSA low order :20Gbit/s UXCSA access capacity :280Gbit/s SXCSA high order :360Gbit/s SXCSA low order :80Gbit/s SXCSA access capacity :280Gbit/s

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top