Which ports on CE switches can be configured with DAD

22

The following ports can be configured with DAD:
- Service port
- Eth-Trunk interface
- Stack port (supported only by the MPU connection mode on CE12800 switches)
- Management port

Other related questions:
Can the SIP ports on CE switches be configured with DAD
SIP ports are used for stack connections, so DAD cannot be configured on such ports.

Can the management ports on CE switches be configured with DAD
The management ports on the stack member switches can be configured with DAD. IP addresses must be configured during DAD configuration.

Can DAD-enabled ports on a CE switch run services
Ports configured with dual-active detection (DAD) in direct mode cannot run other services. Eth-Trunks configured with DAD in relay mode can run other services properly.

Can the stack ports on CE switches be used for DAD
When the MPU connection mode is used on CE12800 switches, stack ports can be configured with DAD.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top