Homepage FAQ Switch

How to configure an FC interface on a CE series switch

101

Before configuring an FC interface, install an FC optical module. If the LINK indicator of a service interface is steady green, the interface is in Up state.
# Switch 10GE1/0/1 to an FC interface.
system-view
[~HUAWEI] port mode fc 10ge 1/0/1
Warning: This operation will cause all the other configurations on the port to be lost. Continue? [Y/N]:y
[*HUAWEI] commit
# After configuring an FC interface, check the interface status. If the physical state and protocol state of the interface are both UP, the interface has been enabled.
[~HUAWEI] display interface fc 1/0/1
FC1/0/1 current state : UP (ifindex: 144)
Line protocol current state : UP
......

Other related questions:

Do CE series switches support the FC function

CE series switches support the FC function in V100R005C10 and later versions. Currently, only the CE6850U-HI supports the FC function.

How to configure the MTU for an interface on a CE series switch

The procedure for configuring the MTU for an interface on a CE series switch is described on the right.

How to configure the interface rate on a CE series switch

The following uses a 10GE electrical interface as an example to describe how to configure the interface rate. # Set the rate of electrical interface 10GE1/0/1 working in auto-negotiation mode to 1000 Mbit/s. system-view [~HUAWEI] interface 10ge 1/0/1 [~HUAWEI-10GE1/0/1] speed auto 1000 [*HUAWEI-10GE1/0/1] commit # Set the rate of electrical interface 10GE1/0/1 working in non-auto-negotiation mode to 1000 Mbit/s. system-view [~HUAWEI] interface 10ge 1/0/1 [~HUAWEI-10GE1/0/1] negotiation disable [*HUAWEI-10GE1/0/1] speed 1000 [*HUAWEI-10GE1/0/1] commit

If you have more questions, you can seek help from following ways:

To WeiKnow To Live Chat

Enterprise

Consumer

Corporate

Carriers

How to configure an FC interface on a CE series switch

Other related questions:

If you have more questions, you can seek help from following ways: