Load a license file to a standalone switch

4

Perform the following steps to load a license file to a standalone switch:
1. Upload the license file.
2. Run the following command to activate the license file.
license active license.dat
Now activing the license.................................done.
MainBoard:
Info: Succeeded in activating the license file on the board.

Other related questions:
Load a license file to a stack of switches
Perform the following steps to load a license file to a stack system: 1. Apply for a license and upload the license file to the master switch of the stack system. A license is bound to the ESN of a physical device, and each stack member has an independent ESN. You can apply for a license for two switches in a stack or for each switch. 2. Run the license active file-name command in the user view to activate the uploaded license file. ? If there are multiple license files, run the license active file-name command multiple times and specify different file names each time. The system will then find the matching ESNs to activate the license files. ? If there is only one license file, run the license active file-name command only once. 3. Run the display license command to check whether the license file has been successfully loaded. If you load the licenses on multiple switches and then set up a stack system, the features activated for the stack are a combination of features activated for the member switches. If a license is uploaded to only one of the two switches, the license is valid for the stack system. If the stack system splits, the licenses loaded to the switches respectively take effect. In addition, the activated licensed features can still be used on the switches even if these features are not activated using the switches' own license. If the license of Switch1 supports feature A and the license of Switch2 supports feature B, the two switches support features A and B after they set up a stack. If the stack breaks, feature B on Switch1 can still run even after Switch1 restarts but new configurations cannot be added to feature B.

For CE switches, should a license file be loaded before or after a stack is set up
You can load license files for switches before or after setting up a stack. The result is not affected by the operation sequence.

Can the license information be queried after the standby U1981 device has loaded the license?
The license of the standby device only has the DR control item.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top