Homepage FAQ Switch

Whether S series switches support the speed limit per IP address

125

S series switches (except S1700) do not support the speed limit per IP address

Other related questions:

Whether the DHCP function of S series switch support static IP address check

After DHCP snooping is configured, S series switches do not check static IP addresses by default. You can enable the IPSG function and configure static binding entries to enable the static IP address check function.

Whether S series switch frame device configuration can configure speed limit after the link port

S series switch frame device support to configure inbound speed limit function at Eth-Trunk interface(using the command QoS car), after the configuration: - If the members are on different board, then every interface enjoy alone the speed. - If the members are on the same board, then every interface share the speed, and the shared bandwidth is shared in a random manner.

The unit of S series switch speed limit

S series switches (except S1700) speed limit is kbit/s.

Do S series switches support rate limiting based on IP addresses

S series switches (except S1700 switches) do not support rate limiting based on IP addresses.