Whether S series switches support to configure bandwidth based on percentage

S series switches do not support NAT, but S series modular switches configured with SPUs support NAT. 1. S series fixed switches do not support NAT. 2. S7700 and S9700 series modular switches configured with SPUs support NAT. 3. S9300 series modular switches configured with SPUs support NAT. 4. S12700 series modular switches do not support NAT.

For details on whether S series switches in V200R008 and earlier versions support or do not support OSPF, see the following: �?S7700/S9700/S12700: Support �?S9300: Support �?S6720EI: Support �?S6700EI: Support �?S5720HI: Support �?S5710HI: Support �?S5700HI: Support �?S5720EI: Support �?S5710EI: Support �?S5700EI: Support �?S5720SI/S5720S-SI: Support �?S5700SI: Not support �?S5710LI: Not support �?S5700LI: Not support �?S5700S-LI: Not support �?S3700HI: Support �?S3700EI: Support �?S3700SI: Not support �?S2750EI: Not support �?S2720EI: Not support �?S2700EI: Not support �?S2710SI: Not support �?S2700SI: Not support �?S1720: Not support For details on whether S series switches in V200R008 and earlier versions support or do not support OSPFv3, see the following: �?S7700/S9700/S12700: Support �?S9300: Support �?S6720EI: Support �?S6700EI: Support �?S5720HI: Support �?S5710HI: Support �?S5700HI: Support �?S5720EI: Support �?S5710EI: Support �?S5700EI: Support �?S5720SI/S5720S-SI: Support �?S5700SI: Not support �?S5710LI: Not support �?S5700LI: Not support �?S5700S-LI: Not support �?S3700HI: Support �?S3700EI: Support �?S3700SI: Not support �?S2750EI: Not support �?S2720EI: Not support �?S2700EI: Not support �?S2710SI: Not support �?S2700SI: Not support �?S1720: Not support

Traffic cannot be controlled by bandwidth percentage on S series modular switches. However, you can use the following methods to control traffic. In the interface view, run the storm-control { broadcast |multicast | unicast } min-rate min-rate-value max-rate max-rate-value command to specify the upper and lower thresholds of the rate. If min-rate-value is specified, the interface forwards only the packets of which the rate is smaller than the value of min-rate-value within the detection interval. If max-rate-value is specified, the interface is blocked or shut down when it receives packets of which the rate is larger than the value of max-rate-value. Run the storm-control action { block | error-down } command in the interface view to set the action to shutdown.

S series switch (except S1700) switch does not support bandwidth reservation of interface, but can improve the priority of a specific message through the queue of flow, to ensure that the specific types of messages be sent out.

SNMP is a basic feature of S series switches (except S1700), and is supported by all device models and versions.