Rate limit for DHCP packets on specified interfaces of S series switch

2

For S series switches in V100R006 and later versions, only the S3728 in S3700 series switches supports the interface-based rate limit for DHCP packets.

Other related questions:
Can the switch limit the rate of DHCP packets on specified interfaces
Hardware-based rate limiting for DHCP packets can be configured on specified interfaces since V100R006. In the S3700 series, only the S3728 supports this configuration.

How to configure ARP packet rate limit on S series switcheses
For S series switcheses (except S1700 switches): You can configure the rate limit on ARP packets in one of the following methods as required: - Limiting the rate on ARP packets based on source MAC addresses (supported by the S5720EI, S5720HI, S6720EI, and all S series modular switches, but not supported by E series switches) # Set the maximum rate of ARP packets from the specified MAC address 0-0-1 to 50 pps. [HUAWEI] arp speed-limit source-mac 0-0-1 maximum 50 - Limiting the rate on ARP packets based on source IP addresses # Set the maximum rate of ARP packets from the specified IP address 10.0.0.1 to 50 pps. [HUAWEI] arp speed-limit source-ip 10.0.0.1 maximum 50 Limiting the rate on ARP packets globally, in a VLAN, or on an interface # Configure Layer 2 interface GE0/0/1 to allow 200 ARP packets to pass through in 10 seconds, and to discard all ARP packets in 60 seconds when the number of ARP packets exceeds the limit. [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] arp anti-attack rate-limit enable [HUAWEI-GigabitEthernet0/0/1] arp anti-attack rate-limit packet 200 interval 10 block-timer 60 - Limiting the rate on ARP packets on a VLANIF interface of a super-VLAN # Set the maximum rate of broadcasting ARP Request packets on VLANIF interfaces in all super-VLANs to 500 pps. [HUAWEI] arp speed-limit flood-rate 500

Do S series switches support time-based rate limiting on interfaces
S series switches (except S1700 switches) do not support time-based rate limiting on their interfaces. You can configure traffic policing using ACLs and traffic policies for rate limiting in a specified time range. For a configuration example, see "Example for Configuring Rate Limiting in a Specified Time Range" in ARP rate limiting on S series switch
An S series switch, except S1700, can limit the rate of ARP packets and ARP Miss messages. When the switch receives many ARP packets, configure ARP packet rate limiting to prevent CPU overloading. When the switch receives many IP packets of which the destination IP addresses cannot be resolved, the switch generates a large number of ARP Miss messages, delivers temporary ARP entries and sends may ARP request packets to the destination network. This increases CPU load and consumes bandwidth. To avoid IP packet attacks, configure ARP Miss rate limiting on the switch.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top