Do S series switches support static multicast routes

25

For S series switches, static multicast routes are supported only by S series modular switches, S3700EI, S3700HI, S5720S-SI, S5720SI, S5700EI, S5710EI, S5720EI, S5700HI, S5710HI, S5720HI, S6700EI, S6720EI and S6720S-EI. You can run the igmp static-group command to configure a static multicast group, and the ip rpf-route-static command to configure a static multicast route.

Other related questions:
Does an S series switch support the multicast static route port
The switch enabled with IGMP snooping forwards multicast packets to the multicast router only through the router port after receiving IGMP Report messages. The router port is dynamically learned by the switch after the interface receives a General Query message or a PIM Hello packet from the multicast router. If the multicast router cannot send IGMP General Query messages, the router port must be statically configured. S series excluding the S1700 and E series switches support the static router port. You can use the igmp-snooping static-router-port command in the interface view.

Do S series switches support static multicast MAC addresses
S series switches (except the S1700) support static multicast MAC addresses in V100R006 and later versions. However, the support for this function varies depending on switch models. - S2700SI/S2700EI: not supported - S3700SI/S3700EI: not supported - S5710-C-LI: not supported - S5700SI: supported in V200R003 and later versions

Whether S series switches support IPSG
All S series switches except the following support IPSG: S1700 switches S2700-SI switches W series cards of S7700, S9700, and S1270 switches S9300 of earlier versions than V100R002 For switches that do not support IPSG, you can run the mac-address static vlan command to configure static MAC addresses and run the mac-address learning disable command to disable MAC address learning on interfaces to realize a function similar to IPSG.

How to configure floating static routes with S-series switches
When there are multiple routes to a destination, you can configure different routes with different priorities

Static ARP support on S series switches
S series switches (except S1700 switches) support static ARP entries.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top