How to take effect by S Series Switch Configure extended routing table space resource function?

1

After you configure the extended routing table space resource function through CLI command "assign resource-mode", you need to reboot the board to take effect.

Other related questions:
How does the extended routing entry resource mode take effect on an S series switch
Q: Why do some packets still fail to be forwarded after the extended routing entry resource mode is configured to address the problem of excess routing entries? A: After running the assign resource-mode command to configure the extended routing entry resource mode on a card, you must reset the card for the configuration to take effect.

DHCP configuration on S series switch does not take effect
DHCP configuration may not take effect on an S series switch due to the following reasons: 1. DHCP server is disabled on the switch. 2. The DHCP address pool is configured incorrectly. 3. No IP network segment is specified on the interface connected to DHCP clients, or the specified IP network segment is on a different network segment from the address pool. 4. If ACL resources are exhausted, the DHCP commands run globally or on an interface will not take effect.

S series switch routing table specification
Hello, I now have no way to answer this question, for the specifications of the performance class, you can call 4008229999 pre-sale manual service consulting.

Why static routes imported to OSPF on an S series switch fail to take effect
Question: Why do static routes imported to OSPF fail to take effect? Answer: If a static route imported to OSPF has a lower precedence than other routes, OSPF does not advertise this static route.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top