How to view ARP entries

2

Run the display arp [ interface interface-type interface-number | dynamic | static ] [ | { begin | include | exclude } text ] command to view the ARP entries.

Other related questions:
View ARP entries on S series switches
If an S series switch (except the S1700 switch�? works at Layer 2, you can only view the MAC addresses of devices connected to an interface, not the IP addresses. You can run the display mac-address command. The command output is as follows: MAC address table of slot 0: MAC Address VLAN/ PEVLAN CEVLAN Port Type LSP/LSR-ID VSI/SI MAC-Tunnel 5489-980d-4ef6 1 - - GE0/0/1 dynamic 0/- 5489-98c2-19e3 20 - - GE0/0/2 dynamic 0/- Total matching items on slot 0 displayed = 2 ——————————————————————————————————————�?If an S series switch (except the S1700 switch�? works at Layer 3, you can run the display arp [ all ] command to view ARP entries including mappings between IP addresses and MAC addresses. In addition, you can find the outbound interfaces toward the devices based on the mappings. The command output is as follows: IP ADDRESS MAC ADDRESS EXPIRE(M) TYPE INTERFACE VPN-INSTANCE VLAN/CEVLAN 10.137.217.202 00e0-0987-7890 I - Eth0/0/0 10.137.216.1 0000-5e00-0149 20 D-0 Eth0/0/0 Total:2 Dynamic:1 Static:0 Interface:1 ———————————————————————————————————————�?With known MAC addresses or IP addresses, you can obtain outbound interfaces and mappings between IP addresses and MAC addresses of specific devices based on the MAC table or ARP table on the switch. In the preceding output, if the MAC ADDRESS field is Incomplete, the ARP entry is temporary. When an IP packet triggers an ARP Miss message, the switch generates a temporary ARP entry and sends ARP Request packets to the destination network segment. The following situations may occur before the temporary ARP entry ages: Before receiving an ARP Reply packet, the switch discards IP packets matching the temporary ARP. No ARP Miss message will be triggered. After receiving the ARP Reply packet, the switch generates a correct ARP entry to replace the temporary ARP entry. When the temporary ARP entry expires, the switch deletes it.

Delete ARP entries on S series switch
On an S series switch, except S1700, run the reset arp { all | dynamic [ ip ip-address [ vpn-instance vpn-instance-name ] ] | interface interface-type interface-number [ ip ip-address ] | static } command in the user view to delete ARP entries. The parameters are as follows: all: deletes all ARP entries. dynamic: deletes dynamic ARP entries. static: deletes static ARP entries. interface: deletes ARP entries on the specified interface. ip-address: deletes ARP entries of the specified IP address. vpn-instance: deletes ARP entries in the specified VPN instance. Run the undo arp static ip-address mac-address [ vpn-instance vpn-instance-name | [ vid vlan-id [ cevid ce-vid ] ] interface interface-type interface-number[.subinterface-number ] ] or undo arp static ip-address [ vpn-instance vpn-instance-name | vid vlan-id [ cevid ce-vid ] interface interface-type interface-number[.subinterface-number ] ] command in the system view to delete ARP entries.

How to display all the ARP mapping entries ?
Check whether the AP has obtained an IP address based on the MAC address, and ping the IP address. display arp

Number of ARP entries on S series switch
Hi, I can't answer this question. For details about product specifications, click http://e.huawei.com/en/service-hotline to look up the contact method of your local customer service engineers.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top