Can I view the port number on an S series switches

3

No command is available to display the port number of a data packet on an S series switches. To obtain the port number of a data packet, run the display mac-address command to view the source MAC address of the packet, determine the port receiving the packet, and then use Wireshark to capture it.

Other related questions:
Can I view the port number on an S series switches
No command is available to display the port number of a data packet on an S series switches. To obtain the port number of a data packet, run the display mac-address command to view the source MAC address of the packet, determine the port receiving the packet, and then use Wireshark to capture it.

Whether the S-series switch can view the port number of the connection
The S series switches can not use the CLI to view the port number of the data packets. You can only view the data from which port into refer to source mac by using the display mac-address. You can capture the data through the capture package software named wiresharp to view.

In which views can IPSG be enabled on S series switches
IPSG can be enabled on an S series switch (except the S1700) in an interface or a VLAN view. Interface views include the Ethernet interface view, GE interface view, 40GE interface view, XGE interface view, 100GE interface view, Eth-Trunk interface view, and port group view. Example 1: Enable IPSG in the GE0/0/1 view. [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] ip source check user-bind enable Example 2: Enable IPSG in the VLAN 100 view. [HUAWEI] vlan 100 [HUAWEI-vlan100] ip source check user-bind enable

SNMP port numbers of S series switches
After SNMP is configured on S series switches (except S1700), UDP ports are enabled by default. By default, the port number for SNMP and NMS connection is 161 and the port number for sending alarms to the NMS is 162.
You can use the snmp-agent udp-port port-num command to configure the port number for SNMP and NMS connection.

Can community attributes be viewed on an S series switch
For an S series switch (except S1700), you can view the community read-write attribute in the device's configuration file. You can also view the community read-write attribute on the SNMP feature page of the web NMS.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top