What is the difference between the link aggregation group in LACP mode and in manually configured link aggregation group in terms of forwarding performance

0

For S series switches (except the S1700), there is no difference between an LACP aggregation group and a manually configured link aggregation group in terms of forwarding performance.

Other related questions:
Configuring link aggregation in LACP mode on CE switches
LACP link aggregation can work in static or dynamic LACP mode. Ensure that both ends use the same working mode. That is, if the local end works in static LACP mode, the peer end must use the static LACP mode. - If the directly-connected two ends support LACP, the static LACP mode is recommended. - The dynamic LACP mode is generally used when the switch is directly connected to a server. In this case, you can also use the static LACP mode. # Add 10GE1/0/1 to 10GE1/0/3 to Eth-Trunk 1, and set the working mode to static LACP.
<HUAWEI> system-view
[~HUAWEI] interface eth-trunk 1
[*HUAWEI-Eth-Trunk1] mode lacp-static
[*HUAWEI-Eth-Trunk1] trunkport interface 10ge 1/0/1 to 1/0/3
[*HUAWEI-Eth-Trunk1] commit
# Add 10GE1/0/4 to 10GE1/0/6 to Eth-Trunk 2, and set the working mode to dynamic LACP.
<HUAWEI> system-view
[~HUAWEI] interface eth-trunk 2
[*HUAWEI-Eth-Trunk2] mode lacp-dynamic
[*HUAWEI-Eth-Trunk2] trunkport interface 10ge 1/0/4 to 1/0/6
[*HUAWEI-Eth-Trunk2] commit

How to configure load balancing in a link aggregation group
Run the load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac } command in the Eth-Trunk view. The default load balancing mode of the S3700HI, S5700HI, S5706, and S6700 is src-dst-ip; the default load balancing mode of other switches is src-dst-mac.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top