Does the switch support traffic statistics on the Eth-Trunk port

5

In V100R005 and later versions, the command line query is supported. Since the V100R006 version, the MIB query is supported. You can run the display eth-trunk trunk-id verbose command to query traffic statistics of the Eth-Trunk interface and its member ports, or query traffic statistics in MIB objects ifInOctets and ifOutOctets.

Other related questions:
Does the switch support bandwidth statistics on the Eth-Trunk port
Bandwidth statistics include the InUti and OutUti parameters in the port information. Switches of V100R006 and later versions support bandwidth statistics collection for the Eth-Trunk interface. The values of InUti and OutUti are 0 in versions earlier than V100R006. The following is an example: display interface brief InUti/OutUti: input utility/output utility Interface PHY Protocol InUti OutUti inErrors outErrors Eth-Trunk1 up up 0% 0% 0 0 GigabitEthernet0/0/2 up up 21% 42% 634 0 GigabitEthernet0/0/3 up up 36% 37% 979 0 GigabitEthernet0/0/4 up up 31% 42% 978 0

Does the switch Eth-Trunk port support the enhanced load balancing mode
In the enhanced mode, the load balancing can be implemented based on the packet type. In V100R006 and earlier versions, the switches do not support this configuration. In V200R001, only the S5700HI and S5710EI support this configuration. In V200R200 and later versions, the S5700HI, S5710HI, and S5710EI support this configuration. The key configuration commands are as follows: 1. Run the load-balance-profile profile-name command to create the enhanced load balancing template and go to the template view. The load balancing mode can be configured for L2 packets, IPV4 packets, IPV6 packets, or MPLS packets. 2. Go to the Eth-Trunk port view, and run load-balance enhanced profile profile-name to use the enhanced load balancing mode for the Eth-Trunk.

Do S series switches support association between EFM and an Eth-Trunk
S series switches do not support association between EFM and an Eth-Trunk. They support only association between EFM and an interface.

Does an AR support IP traffic statistics
AR routers support IP traffic statistics collection.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top