Can link aggregation be performed when Huawei switch connects to a Cisco switch

18

Link aggregation can be performed when Huawei switch connects to a Cisco switch.

Other related questions:
How can I swop out Cisco with huawei switch ?
1. There may be problems connecting to upstream and downstream equipment. Please refer to the topic. 2. Huawei switches and Cisco switches have different configurations. Refer to the configuration guide. 3, if you still can not solve, please call 400-822-9999

Connect the S series switches to servers by using link aggregation
To connect a standalone or a stacked S series switch (except the S1700) to a server with dual or multiple network adapters, first configure link aggregation on interfaces of the switch. For example, to connect the S5700 to a server with dual network adapters, create an Eth-Trunk between two interfaces on the S5700 and then connect the S5700 to the server using two network cables. You can connect a switch to a server with dual network adapters in the following modes: 1. round robin (link aggregation must be configured on the switch). Characteristics: (1) All the links work in load balancing state and packets are transmitted on a per-packet basis to each link in round robin mode. If you ping the address 10.1.1.1 from the server, packets are transmitted on two network adapters of the server. (2) This mode improves bandwidth and supports error tolerance. If one link fails, traffic is switched to the other normal link. 2. active-backup (This mode can be applied without configuration on the switch). Characteristics: One port works in active state and another port works in backup state. All traffic is transmitted on the active link and there is no traffic on the backup link. If the active port goes Down, the backup port changes to the active state. 3. 802.3ad (link aggregation in LACP mode needs to be configured on the switch). 4. adaptive load balancing (no configuration is required on the switch). In this mode, you do not need to configure the switch because the two network adapters that are bound using bonding technology use different MAC addresses.

Can S series switches interconnect with non-Huawei devices to set up a VRRP group
S600-E series switches do not support VRRP. VRRP supported by S series switches (S1700 excluded) comply with the standard protocol, so these switches can interconnect with other devices that comply with the VRRP standard protocol.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top