how to configure the speed of interface

9

The speed command sets the rate for an Ethernet interface in non-auto negotiation mode.
By default, an Ethernet interface works at its highest rate when it works in non-auto negotiation mode.
Example
# Configure GE0/0/1 to work at 100 Mbit/s in non-auto negotiation mode.
system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] undo negotiation auto
[HUAWEI-GigabitEthernet0/0/1] speed 100

Other related questions:
How is an NE router's interface speed modified
Run the speed command in the interface view to modify the interface speed. Different types of interfaces support different speeds. Configure an acceptable speed based on the speed range displayed on the NE device.

How to configure the speed dial function on the LCD screen of the eSpace 7910?
On the LCD screen of the IP phone, choose Application > personalized > key > Programmable Button. On the Programmable Button screen, configure the speed dial numbers.

Adjusting the fan speed of the USG6000
To adjust the fan speed, run the test fan-speed fan-id fan-speed command in the diagnose view. This command involves two parameters. fan-id specifies the fan ID, which can be 0, 1, and 2. 0 and 1 specify the ID of the corresponding fan, and 2 indicates all fans. fan-speed specifies the fan speed, which is an integer ranging from 0 to 4 or 0 to 7, according to the model. A larger value indicates a faster fan speed. The maximum value indicates that the fan runs at the full speed.

IAD how to achieve speed dial
1.pound # when finish dial: 2.cofigiuration a digitmap for IAD: on the IAD,in the global mode,and executive command:display sip digitmap if user on IAD dial number is 0159xxxxxxxx,you can cofigiuration a digitmap 0159xxxxxxxx,achieve begin at 0159 12 phone number 。 3.open bit by bit function: We can not config the bit by bit function on IAD,but we can turned on the feature on a soft - switching voice gateway device, which can be implemented with the following configuration: Unified gateway configuration in U1900, open the bit by bit reporting function: #config modify digitmap protocol sip sendmapswitch on #config softargu type 282 value 1 // sip support IAD dial needn't pound # Default "0" is off #config add digitmap protocol sip value x Unified gateway configuration in U1900, turn off the bit by bit reporting function: #config modify digitmap protocol sip sendmapswitch off #config softargu type 282 value 0 // sip support IAD dial needn't pound # Default "0" is off #config delete digitmap protocol sip value x If the field IAD equipment is less, it is recommended to configure the SIP digitmap on the IAD device. Specific configuration please refer to the corresponding model of the product documentation.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top