S series switches during the upgrade process unexpected power failure, upgrade failed

0

S series switches (except S1700) set to start from a large package after the reset, if any loss occurs in the process, the software that the package can not start normally, will find the last successful start of the large package file.

Other related questions:
Upgrade stacks of S series fixed switches
You can upgrade a stack of S series fixed switches using either of the following methods: Traditional upgrade: All member switches in the stack need to restart. This upgrade method causes service interruption in a relatively long time and can be used in scenarios insensitive to the service interruption time. Upgrade procedure 1. Upload system software to the master switch in the stack. 2. Run the startup system-software system-file all command to set the next startup software for all member switches in the stack. 3. Run the reboot command to upgrade the stack by restarting the entire system. Smooth upgrade: Member switches in a stack can be divided into an active area and a backup area that back up each other. Member switches in the two areas are upgraded in turn. During the upgrade of an area, traffic is transmitted through the other area, minimizing the impact of the upgrade on services. This upgrade method applies to scenarios sensitive to the service interruption time. The stack and networking must meet the following requirements: The uplinks and downlinks work in redundancy mode. The system software for next startup supports the smooth upgrade function. Member switches in the stack are running the same system software with the same software package name, version, and path. Member switches in the stack have the same system software for next startup with the same software package name, version, and path. Upgrade procedure 1. Upload system software to all the member switches in the stack. Ensure that member switches have the same system software with the same software package name, version, and path. 2. Run the system-view command to enter the system view. 3. Run the upgrade backup-area slot slot-id to slot-id command to define the active and backup areas for a smooth upgrade. The member switches with stack IDs in the specified range join the backup area, and the other member switches automatically join the active area. Note: Follow these rules to define the active and backup areas in a stack: The active and backup areas cannot contain the same member switch, and both areas must have at least one member switch. The backup area cannot contain the master switch. Member switches in each area must be directly connected. Member switches in the active and backup areas form the entire stack. 4. (Optional) Run the display upgrade area command to check whether the configured areas meet the requirements of the current stack topology. If the stack topology changes after the areas are configured, the smooth upgrade will fail. To avoid this problem, check the area configuration before starting a smooth upgrade. If the areas fail the check, redefine the active and backup areas correctly according to the current stack topology. 5. Run the upgrade start command to enable a smooth upgrade. 6. (Optional) Run the display upgrade state [ slot slot-id ] command to check the smooth upgrade status.

Camera upgrade failure
Here below lists the possible causes and solutions. Cause 1: The serial cable is faulty or connected incorrectly. Solution: Check the serial cable connection and ensure that the PC serial cable is connected to the COM-OUT port of the camera (COM-IN is used for control and COM-OUT for upgrade). Cause 2: The PC serial port is selected incorrectly. Solution: Ensure that the selected serial port is select correctly: The COM1 to COM4 ports of the PC upgrade tool must be consistent with that of the actual PC serial port

Why an ISSU upgrade fails on a CE series switch
If a card fails to start using the system software of a new version, an ISSU upgrade will fail and the system will be rolled back to the previous version.

Whether the S-series box-type switch upgrades requires a separate upgrade of the LPU
S series box switch upgrade, only need to complete the main control board upgrade, do not need to upgrade the business board alone.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top