How to check whether the cable on an Ethernet interface is working properly

17

Run the virtual-cable-test command to test the cable on an Ethernet interface.

# Test the cable connected to Ethernet electrical interface GigabitEthernet 0/0/1.

system-view
[HUAWEI] interface GigabitEthernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] virtual-cable-test
Warning: The command will stop service for a while, Continue [Y/N]?y
Pair A length: 189meter(s)
Pair B length: 189meter(s)
Pair C length: 189meter(s)
Pair D length: 189meter(s)
Pair A state: Ok
Pair B state: Ok
Pair C state: Ok
Pair D state: Ok
NOTE:
Status of a circuit pair of the cable.
OK: indicates that the circuit pair is terminated normally.
Open: indicates that the circuit pair is not terminated.
Short: indicates that the circuit pair is short circuited.
Crosstalk: indicates that the circuit pairs interfere with each other.
Unknown: indicates that the circuit pair has an unknown fault.

Other related questions:
Checking server hard disk status
You can use any of the following methods to check hard disk status: 1. Check each hard disk status indicator. 2. Check hard disk status on the iMana WebUI. 3. Check hard disk status in the Configuration Utility of the RAID controller card.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top