Restore a stack port to a service port on an S series switch

117

For S series switches of versions later than V200R002, run the following command:

[HUAWEI] interface stack-port 0/1
[HUAWEI-stack-port0/1] shutdown interface xgigabitethernet 0/0/5
[HUAWEI-stack-port0/1] undo port interface xgigabitethernet 0/0/5 enable

For V200R002 and later versions:
1. S5700LI or S5710EI

[HUAWEI] interface stack-port 0/1
[HUAWEI-stack-port0/1] undo port member-group interface gigabitethernet 0/0/28
[HUAWEI-stack-port0/1] quit
[HUAWEI] undo stack port interface gigabitethernet 0/0/28 enable

2. S6700EI

[HUAWEI] interface stack-port 0/1
[HUAWEI-stack-port0/1] undo port member-group interface xgigabitethernet 0/0/1
[HUAWEI-stack-port0/1] undo port member-group interface xgigabitethernet 0/0/2
[HUAWEI-stack-port0/1] undo port member-group interface xgigabitethernet 0/0/3
[HUAWEI-stack-port0/1] undo port member-group interface xgigabitethernet 0/0/4
[HUAWEI-stack-port0/1] quit
[HUAWEI] undo stack port interface xgigabitethernet 0/0/1 to 0/0/4 enable

Other related questions:
How to restore a CSS port to a service port for the CSS composed of S series modular switches
Perform either of the following operations: 1. In non-CSS scenarios, to restore a physical member port to a service port on a standalone switch, run the undo interface css-port command in the system view. 2. In CSS scenarios, to restore a physical member port to a service port in a CSS, run the shutdown interface ** command in the logical CSS port view (run the interface css-port port-id command to enter the view) to shut down the physical member port and then run the undo port interface ** enable command.

If two service ports on an S series fixed switch are configured as stack ports, can other service ports on the switch that are not configured as stack ports be used to run services
For most S series fixed switches, the ports that are not configured as stack port can still run services. For example, when two rear SFP ports on an S5700-52P-LI switch are configured as stack ports, the other two rear SFP ports can forward service data. However, on the S6700EI and S6720EI, every four ports are added to one group. A group of ports must function as stack ports or service ports together. That is, when one port is configured as a stack port, the other three ports in the same group will automatically be configured as stack ports but cannot function as service ports.

Service ports on S series fixed switches that support stacking
For details about service ports on S series fixed switches that support stacking, click Typical Configuration Examples and choose Typical Stack Configuration of Fixed Switches- Determining the Stack Connection Mode and Hardware and Software Requirements. This section describes whether each model and version of S series fixed switches supports stacking as well as stack modes, hardware and software requirements, typical networking, and configuration steps to set up stacks.

Do CE series switches support service port stacking
Yes CE series switches support service port stacking.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top