Can NDP be configured on the Eth-Trunk

2

For S series switches excluding the S1700, NDP can be configured on the Eth-Trunk.

Other related questions:
Can NDP be configured on the Eth-Trunk
For S series switches excluding the S1700, NDP can be configured on the Eth-Trunk.

Why the NDP/NTDP configuration of a switch Eth-Trunk member port cannot be deleted
It has two situations: For a physical port, no configuration is performed before the Eth-Trunk is added. After ntdp enable is configured, ntdp enable is displayed for buildrun. If undo ntdp enable is configured, undo ntdp enable is displayed. See the following information: interface GigabitEthernet0/0/9 #interface GigabitEthernet0/0/9 ntdp enable #interface GigabitEthernet0/0/9 undo ntdp enable #The cause is that there are three states (not configured, enabled, disabled) for the NDP/NTDP in the V100R005 version. Therefore, if the enabled or disabled state is configured, the value of buildrun is written. After the physical port is added to the Eth-Trunk1, the NDP/NTDP configuration cannot be deleted. See the following information: interface GigabitEthernet0/0/9 eth-trunk 1 undo ntdp enable undo ndp enable The cause is that the physical port can be added to the Eth-Trunk1 only after the NDP/NTDP is disabled, and after the addition the NDP/NTDP cannot be enabled.

Can NTDP be configured on the Eth-Trunk
For S series switches excluding the S1700, NTDP can be configured on the Eth-Trunk.

Can an Eth-Trunk Be Configured with an IP Address?
By default, an Eth-Trunk is a Layer 2 interface and cannot be configured with an IP address. If an Eth-Trunk is switched to a Layer 3 interface, it can be configured with an IP address.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top