Configure routes through the web for S series switches

5

S series switches (except the S1700) supports static IPv4 and IPv6 route configurations on the Classic Web System. (Static IPv6 routes can be configured for V200R009 and later versions.)
1. Choose IP Routing > IPv4 Route in the navigation tree to open the IPv4 Route page. Then click the IPv4 Static Route.
2. Click Create to open the Create an IPv4 Static Route page.
3. Set parameters.
4. Click OK.
5. Click Save in the navigation tree.
The configuration procedure of static IPv6 routes is similar to that of static IPv4 routes.

Other related questions:
Configure the priority of an OSPF route on an S series switch
The routing protocols may share and select the routing information because a switch may run multiple dynamic routing protocols simultaneously. In this case, a priority should be set for each routing protocol. When different protocols find multiple routes to the same destination, the route discovered by the protocol with a higher priority is preferred. On an S series switch, you can run the preference command in the OSPF process view to configure the OSPF priority. Perform the following operations: 1. Run the ospf [ process-id ] command in the system view to enter the OSPF process view. 2. Run the preference [ ase ] { preference | route-policy route-policy-name } * command to configure the OSPF priority. The parameters are described as follows: ase: indicates the priority of the AS-External route. preference: indicates the OSPF route priority. A smaller value indicates a higher priority. route-policy route-policy-name: indicates the priority for specified routes in the routing policy. The default OSPF priority value is 10. When an ASE is specified, the default OSPF priority is 150. For example, set the priority of routes in OSPF process 100 to 150 as follows: [HUAWEI] ospf 100 [HUAWEI-ospf-100] preference 150

How to configure a route through the web NMS on an AR router
To configure a static route, do as follows: 1. Choose IP Service > Route > Static Route Configuration. . 2. Click Create in the IPv4 Static Route Configuration Table or IPv6 Static Route Configuration Table according to requirements to enter the parameter configuration page. 3. Configure parameters one by one, and click OK to complete the configuration. To configure a dynamic route, do as follows: - Configure the OSPF function. 1. Choose IP Service > Route > Dynamic Route Configuration > OSPF to enter the OSPF List page. 2. Click Create, enter parameters, and click ok to create an OSPF process. 3. On the OSPF List page, select the new OSPF process, click Advanced at the right side, click the Basic or Advanced tab page, and modify the OSPF process parameters according to requirements. - Configure the BGP function. 1. Choose IP Service > Route > Dynamic Route Configuration > BGP, configure parameters, and click Apply. 2. On the Peer Configuration List page, click Create, enter parameters, and click ok to create a BGP neighbor.

Configure a stacked S series switch on the web page
S series switches in a stack can be configured on the web page.

How to configure floating static routes with S-series switches
When there are multiple routes to a destination, you can configure different routes with different priorities

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top