How does the S-series switch configure the default gateway

3

[Quidway]ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

Other related questions:
How to configure the default gateway on an S series switches
In the routing table, the default route is a special route with destination network 0.0.0.0 and subnet mask 0.0.0.0. If the destination IP address of a packet does not match any specific entry in the routing table, the default route is selected for packet forwarding. Generally, for low-end S series switches, a default route to the management gateway is configured. The configuration details are as follows: [Quidway]ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

How to configure a gateway address in the IPv6 address pool on S series switches
When configuring the IPv6 address pool on S series switches (excluding the S1700), you do not need to configure a gateway address.

Enable and disable PoE on an S series switch
Enable or disable the PoE function on S series switches:

1. By default, the PoE function is enabled on an interface
2. Enable or disable PoE power supply.
<HUAWEI>system-view
[HUAWEI]interface gigabitethernet 1/0/0
[HUAWEI-GigabitEthernet1/0/0]undo poe enable  //Disable PoE power supply.
[HUAWEI-GigabitEthernet1/0/0]poe enable       //Enable PoE power supply.

The downlink electrical interfaces of PoE switches support PoE power supply, with up to 30 W power on each interface. The maximum power supply distance is 100 m.
Only ES0D0G48VA00 (S7700)/LE0DG48VEA00 (S9300) cards of modular switches (S7700/S9700/S9300/S12700) support PoE power supply.

If the switch connects to 48 V standard PoE powered devices but cannot negotiate power supply capabilities with the devices, you can run poe force-power on the interfaces to forcibly power on the devices.


If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top