How to connect physically connect a new member? ?

3

Switches can be connected using the stack card connection or a physical interface can be configured as a Service port connection

Other related questions:
Method used to verify the consistency between physical fiber connections and logical fiber connections on Metro 1000
1. The Metro 1000 V2 does not support query for received J0 bytes. You can change the number of J0 bytes to be transmitted at the local end to be different from the number of J0 bytes to be received at the peer end, and then check whether the J0_MM alarm is reported. 2. You can also insert an MS_AIS alarm and check whether the peer end reports the MS_AIS alarm. Exercise caution because this operation will interrupt services.

How Can I Do If the Start Physical IP Address Fails to Be Connected?
If a PC fails to connect to the start physical IP address of the file engine's management network port, perform the following operations: ? Check whether management network cables are correctly connected. ? Ensure that other IP addresses of the file engine are on the same network segment with its start physical IP address. For example, the configured start physical IP address of a file engine is 192.168.1.1/255.255.0.0. The file engine's access network ports must have an IP address from the 192.168.X.X network segment. ? Run ping.

Actions taken if the start physical IP address cannot be connected
If a PC fails to connect to the start physical IP address of a file engine's management network port, perform the following procedure: 1. Ensure that management network cables are correctly connected. 2. Ensure that other IP addresses of the file engine are on the same network segment with its start physical IP address. For example, the configured start physical IP address of a file engine is 192.168.1.1/255.255.0.0. The file engine's access network ports must have an IP address from the 192.168.X.X network segment. 3. Run the ping command.

Whether ODUk SNCP protection switching will fail if logical fiber connections and physical fiber connections are reverse
Yes, ODUk SNCP switching will fail.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top