Web-managed S1700 series switches

68

The following S1700 series switches support web-based management:
Web-managed switch model: S1728GWR-4P
SNMP-based models: S1700-28GFR-4P-AC, S1700-52GFR-4P-AC, S1700-28FR-2T2P-AC, S1700-52FR-2T2P-AC, S1720-20GFR-4TP, and S1720-28GFR-4TP
Only the S1700 series switches of which the name contains the letter w or F support web-based management.
NMS-free switches do not support web-based management.

Other related questions:
Configure traffic shaping on the S1700-FR or S1700-GFR switch
Configure traffic shaping on an S1700-FR or S1700-GFR switch as follows: 1. Choose QoS > Traffic Shaping. 2. Select the interface on which traffic shaping is configured and click Configure. 3. Deselect Unlimited and enter a rate limit range in Minimum Rate/Maximum Rate. 4. Click Apply.

Configure IPSG on the S1700-FR or S1700-GFR switch
Configure IPSG on an S1700-FR or S1700-GFR switch as follows: 1. Choose Security > IPSG. 2. Select the interface on which IPSG is configured and click Configure. 3. Set IPSG Status to Enable. 4. Select an IPSG policy bound to the interface from the IPSG Matching Options drop-down list box. 5. Click Apply. Note: If IPSG is enabled on an interface where no binding table is configured, the interface blocks all IP data packets. IPSG cannot be enabled on a DHCP snooping trusted interface. An interface enabled with IPSG cannot be configured as the trusted interface. If an interface joins an aggregation group, IPSG cannot be enabled on the interface. An interface enabled with IPSG cannot join an aggregation group.

Configure STP on an interface of an S1700-FR or S1700-GFR switch
Configure STP on an interface of an S1700-FR or S1700-GFR switch as follows: 1. Choose Service Management > STP. 2. Click the STP Interface tab. 3. Select an interface from the interface list and click Configure. 4. Configure parameters on the page displayed. 5. Click Apply.

Configure Eth-Trunk on the S1700-FR or S1700-GFR switch
Configure an Eth-Trunk on an S1700-FR or S1700-GFR switch as follows: 1. Add a trunk. a. Choose Interface Management > Eth-Trunk. b. Click New to create a trunk group. c. On the page displayed, configure trunk parameters and add member interfaces to the trunk group. d. Click Apply. 2. Set trunk properties. a. Choose Interface Management > Eth-Trunk. b. Click the editing icon on the right of the trunk to be configured. c. Configure trunk parameters. d. Click Apply.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top