Change the management IP address of an S1700-FR or S1700-GFR switch

24

Change the management IP address of an S1700-FR or S1700-GFR switch as follows:
Choose System Management > IP Management and click the IPv4 tab. Information about the switch management VLAN and IP address is displayed. The default IP address configuration mode is manual mode and the default IP address is 192.168.1.253.
Configure an IP address.
1. Choose System Management > IP Management and click the IPv4 tab.
2. Set the management mode of the switch to DHCP or manual configuration.
3. If you set the management mode of the switch to manual configuration, configure an IP address and a subnet mask.
4. Click Apply.

Other related questions:
Save the configuration of an S1700-FR or S1700-GFR switch
Save the configuration of an S1700-FR or S1700-GFR switch as follows: After all configuration operations are completed, click Parameter Saving in the menu bar.

Add blackhole MAC address entries on the S1700-FR or S1700-GFR switch
Add blackhole MAC addresses to the MAC address table on an S1700-FR or S1700-GFR switch as follows: 1. Choose Service Management > MAC. 2. Select Blackhole MAC Table and click New. 3. On the page displayed, enter information about the blackhole MAC address to be added, and click Apply.

Add static MAC address entries on the S1700-FR or S1700-GFR switch
Add a static MAC address entry for an S1700-FR or S1700-GFR switch as follows: 1. Choose Service Management > MAC. 2. Select Static MAC Table and click New. 3. Select an interface, specify a MAC address for the interface, and click Apply.

Configure traffic shaping on the S1700-FR or S1700-GFR switch
Configure traffic shaping on an S1700-FR or S1700-GFR switch as follows: 1. Choose QoS > Traffic Shaping. 2. Select the interface on which traffic shaping is configured and click Configure. 3. Deselect Unlimited and enter a rate limit range in Minimum Rate/Maximum Rate. 4. Click Apply.

Configure IPSG on the S1700-FR or S1700-GFR switch
Configure IPSG on an S1700-FR or S1700-GFR switch as follows: 1. Choose Security > IPSG. 2. Select the interface on which IPSG is configured and click Configure. 3. Set IPSG Status to Enable. 4. Select an IPSG policy bound to the interface from the IPSG Matching Options drop-down list box. 5. Click Apply. Note: If IPSG is enabled on an interface where no binding table is configured, the interface blocks all IP data packets. IPSG cannot be enabled on a DHCP snooping trusted interface. An interface enabled with IPSG cannot be configured as the trusted interface. If an interface joins an aggregation group, IPSG cannot be enabled on the interface. An interface enabled with IPSG cannot join an aggregation group.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top