Configure an interface of the S1700-FR or S1700-GFR switch as a trunk interface

32

Configure an interface on an S1700-FR or S1700-GFR switch as a trunk interface as follows:
1. Choose Service Management > VLAN and click the Interface tab.
2. Select an interface from the interface list and click Configure to modify the VLAN attributes of the interface.
3. Set the link type of the interface to Trunk and configure a VLAN ID.
4. After completing the configuration, click Apply.

Other related questions:
Configure STP on an interface of an S1700-FR or S1700-GFR switch
Configure STP on an interface of an S1700-FR or S1700-GFR switch as follows: 1. Choose Service Management > STP. 2. Click the STP Interface tab. 3. Select an interface from the interface list and click Configure. 4. Configure parameters on the page displayed. 5. Click Apply.

Configure Eth-Trunk on the S1700-FR or S1700-GFR switch
Configure an Eth-Trunk on an S1700-FR or S1700-GFR switch as follows: 1. Add a trunk. a. Choose Interface Management > Eth-Trunk. b. Click New to create a trunk group. c. On the page displayed, configure trunk parameters and add member interfaces to the trunk group. d. Click Apply. 2. Set trunk properties. a. Choose Interface Management > Eth-Trunk. b. Click the editing icon on the right of the trunk to be configured. c. Configure trunk parameters. d. Click Apply.

Modify the PVID of an interface on an S1700-FR or S1700-GFR switch
Modify the PVID of an interface on an S1700-FR or S1700-GFR switch as follows: 1. Choose Service Management > VLAN and click the Interface tab. 2. Select an interface from the interface list and click Configure to modify the VLAN attributes of the interface. 3. Set the link type of the interface to Trunk or Hybrid, and select Native VLAN. 4. After completing the configuration, click Apply.

Modify attributes of interfaces on the S1700-FR or S1700-GFR switch
Modify the attributes an interface on an S1700-FR or S1700-GFR switch as follows: 1. Choose Interface Management > Ethernet Interface and click the Basic Attributes tab. 2. Select an interface from the interface list, click Configure, and configure the interface state, including the auto-negotiation, rate, duplex mode, and traffic control. 3. Configure other parameters of the interface. 4. After completing the configuration, click Apply. To check the interface state that takes effect, access the Basic Attributes page. Note: a. When configuring an interface to work at a specified rate or in duplex mode, disable the auto-negotiation function of the interface. b. When interfaces on two connected switches work in auto-negotiation mode, the switches choose the highest performance transmission mode based on capabilities of both interfaces. c. The rate and duplex mode of GE SFP interfaces are 1000 Mbit/s and full duplex mode, respectively.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top