Configuring Internet access only within a specified period of time on the USG6000


Configure a time-based security policy.

Other related questions:
Method used to restrict users to access the Internet within a specified period of time for the USG2000 and USG5000
In the NAT policy, run the policy time-range time-name command and configure the policy validity period. In this way, users can only access the Internet within the specified period of time.

Allow specified IP addresses to access the Internet through an interface on an S series switch
You can configure an ACL-based traffic policy and apply the traffic policy to an interface on an S series switch to allow specified IP addresses to access the Internet through the interface. For example, configure GE0/0/1 to allow only the user with the IP address of and prevent all other users to access the Internet. [HUAWEI] acl number 3030 [HUAWEI-acl-adv-3030] rule permit ip source 0 [HUAWEI-acl-adv-3030] quit [HUAWEI] acl number 3031 [HUAWEI-acl-adv-3031] rule permit ip [HUAWEI] traffic classifier test1 [HUAWEI-classifier-test1] if-match acl 3030 [HUAWEI] traffic classifier test2 [HUAWEI-classifier-test2] if-match acl 3031 [HUAWEI] traffic behavior test1 [HUAWEI-behavior-test1] permit [HUAWEI] traffic behavior test2 [HUAWEI-behavior-test2] deny [HUAWEI] traffic policy test [HUAWEI-trafficpolicy-test] classifier test1 behavior test1 [HUAWEI-trafficpolicy-test] classifier test2 behavior test2 [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] traffic-policy test inbound

Do S series switches support time-based rate limiting on interfaces
S series switches (except S1700 switches) do not support time-based rate limiting on their interfaces. You can configure traffic policing using ACLs and traffic policies for rate limiting in a specified time range. For a configuration example, see "Example for Configuring Rate Limiting in a Specified Time Range" in Can the one number link you (ONLY) function be set to take effect within a specified period?
Yes. The method is as follows: 1. Use the CLI to log in to the U1900 series unified gateway and then enter the Config mode. 2 (Optional) Add time segment indexes and bind different numbers to different time segments. For example, you can run the following command to add time segment index 1, where the time segment is from 8:00 to 18:00 from Monday to Friday. config add timerange index 1 weekly mon&tue&wed&thu&fri begintime 8 endtime 18 3. Log in to the web management system. 4. Choose User > SIP User or User > POTS User. 5 On the displayed page, select the number that needs to add service rights and then click Service Configuration. 6. Under Complex service, click Configure next to ONLY service. 7 In the displayed Configure ONLY dialog box, set the ONLY number and validity period within which the ONLY function takes effect as prompted. 8. Click OK. The system displays a message indicating that the configuration is successful. Note: For more details about parameters and related settings, go to Huawei's official website to download the U1900 unified gateway product documentation of corresponding version.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top