Modifying security policies through the CLI of the USG6000

34

On the CLI of the USG6000 series, access the view of a specific policy and run the undo command to remove conditions in the security policy. Then you can add desired conditions or modify the action.

Other related questions:
Assigning interfaces to security zones on the USG6000
Perform as follows to assign interfaces to security zones: 1. Run the firewall zone command to access the corresponding zone. 2. Run the add interface command to add the corresponding interface.

Configuring a policy to restrict port access through the CLI of the USG6000
On the CLI of the USG6000 series, configure a security policy, set the condition to source port and the action to deny.

Configuring a policy to allow port access through the CLI of the USG6000
On the CLI of the USG6000 series, configure a security policy, set the condition to source port and the action to permit.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top