Problem and solution when component package uninstallation fails during dynamic loading

6

If component package uninstallation fails, check whether the component package has been referenced.
If the component package that is being referenced is uninstalled, the uninstallation fails, and the web UI displays a message to indicate the failure.

Other related questions:
Problem and solution when a KVM fails
Possible cause: The problem occurs when the power supply is unstable and has transient breaks after the reconstruction of the UPS. Solution: 1. Reinsert the USB cable. 2. If the problem persists, restart the KVM. 3. Replace the faulty keyboard and mouse or the KVM. 4. If the problem persists, restart the SVP.

Problem and solution when port mapping on the USG6330 fails
If port mapping fails, check first whether the policy is correct and then view the session table information.

Problem and solution when the heartbeat interfaces of the firewalls fail to be directly connected
Troubleshoot as follows: 1. Check whether the cable is properly connected. 2. Check whether the interface has been added to the security zone. 3. Check whether service-manage ping permit is configured under the interface.

Problem and solution when a conflict occurs during address set configuration on the USG6000 series
The conflict occurs because the device is already in the address set.

Problem and solution when the URL category query server fails to be connected
To locate and rectify the fault that the URL category query server fails to be connected, perform the following steps: 1. Check whether there is a URL remote query license. Check whether the URL remote query license is enabled and valid on the CLI or web UI. 2.Check whether the networking and the configuration is correct. a.Run the display url-filter global-configuration command to check whether the server state is Connected. If the state is another value, the server is not connected. b. Check whether the DNS server is correctly configured and test the connectivity between the device and the website sec.huawei.com. This website is Huawei security upgrade and authentication center. To connect to a URL remote query server, the device must pass authentication on this website. If the device cannot access the website, it cannot connect to the URL remote query server. c. Check the URL filtering profile.Run the display url-filter global-configuration command to check whether a country name is configured. If no country name is configured for the firewall, it cannot connect to the URL remote query server. d. Check related configurations on the device.View IPsec and tunnel configurations and check whether connection request packets enter IPsec tunnels. If so, analyze the networking and configuration and ensure that the packets can be correctly sent to the authentication center, scheduling server, and query server. e. View security policies and check whether security policies have blocked connection request packets.Several special IP addresses and port numbers are involved for URL server connections. Ensure that the packets sent to the URL servers can pass the check of security policies. f. Check whether the update host source command is configured.This command has an influence on the source address used to connect to the URL remote query server. If this command is configured, the specified interface address serves as the source address of query packets sent to the URL remote query server.If this command is configured, ensure that the packets in response to the packets sent from the specified address to the URL server can be properly forwarded to the device.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top