Changing the duplex mode on the USG6000

0

Choose Network > Interface on the web UI and configure the duplex mode in auto-negotiation of the advanced option.

Other related questions:
Modify attributes of interfaces on the S1728GWR-4P switch
Modify the attributes (including the auto-negotiation mode, manual setting of port rate, full duplex mode, and traffic control) of an interface on an S1728GWR-4P switch using either of the following methods: 1. Port-based configuration: a. Choose Interface > Port > General. b. Select Configure by Port Range from the Action drop-down list box. Configure parameters of interfaces within a range in a batch. c. After completing the configuration, click Apply. The configuration takes effect immediately. To check status of each interface, choose Interface > Port > General and select Show Information from the Action drop-down list box.�?2. Port list based configuration: a. Choose Interface > Port > General. b. Select Configure by Port List from the Action drop-down list box. Configure parameters of each interface. c. After completing the configuration, click Apply. The configuration takes effect immediately. To check status of each interface, choose Interface > Port > General and select Show Information from the Action drop-down list box.

Modify attributes of interfaces on the S1700-FR or S1700-GFR switch
Modify the attributes an interface on an S1700-FR or S1700-GFR switch as follows: 1. Choose Interface Management > Ethernet Interface and click the Basic Attributes tab. 2. Select an interface from the interface list, click Configure, and configure the interface state, including the auto-negotiation, rate, duplex mode, and traffic control. 3. Configure other parameters of the interface. 4. After completing the configuration, click Apply. To check the interface state that takes effect, access the Basic Attributes page. Note: a. When configuring an interface to work at a specified rate or in duplex mode, disable the auto-negotiation function of the interface. b. When interfaces on two connected switches work in auto-negotiation mode, the switches choose the highest performance transmission mode based on capabilities of both interfaces. c. The rate and duplex mode of GE SFP interfaces are 1000 Mbit/s and full duplex mode, respectively.

How to check the interface duplex mode of an AR router
Duplex modes: - Half-duplex: An interface can either receive or send data at one time. The maximum transmission distance is also limited. - Full duplex: An interface can receive and send data simultaneously. The maximum throughput can be twice of the interface rate. In addition, the transmission distance is not limited. You can run the display interface ethernet brief command to check the brief information about the Ethernet interface of a router, including the physical state, auto-negotiation method, duplex mode, rate, and average bandwidth utilization rate in the receiving and sending directions in the recent period of the interface. In the displayed information, the Duplex column indicates the duplex mode of the interface, which can be one of the following modes: ? full: Indicates that the interface works in full-duplex mode. ? half: Indicates that the interface works in half-duplex mode. ? In auto-negotiation mode, you can run the auto duplex command to configure the duplex mode of an interface. ? In non-auto negotiation mode, you can run the duplex command to configure the duplex mode of an interface.

Can Ethernet interfaces be configured to work in half duplex mode
The following interfaces can work in half-duplex mode at the rate of 10 Mbit/s or 100 Mbit/s: FE electrical interfaces, GE electrical interfaces, and GE optical interfaces with GE copper modules installed

USG6000 routing mode
The USG6000 supports four types of smart routing modes: load balancing based on the link bandwidth, load balancing based on the link weight, active/standby backup based on the link priority, and load balancing based on the link quality. The global smart routing does not support load balancing based on the link quality. The policy-based routing supports all of the four routing modes.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top