Method used by NAT Server to call the service set on USG firewalls

2

NAT Server cannot call the service set.

Other related questions:
Whether UDP can be specified for NAT Server configured for the USG2000 and USG5000 series
You can configure the UDP port mapping when configuring NAT Server for the USG2000 and USG5000 series. The configuration method is the same as that for TCP port mapping. [USG]nat server protocol udp global 1.1.1.1 10000 inside 2.2.2.2 10000 [USG]disp nat server id : 3 zone : --- interface : --- global-start-addr : 1.1.1.1 global-end-addr : --- inside-start-addr : 2.2.2.2 inside-end-addr : --- global-start-port : 10000(hwcc) global-end-port : --- insideport : 10000(hwcc) globalvpn : public insidevpn : public protocol : udp vrrp : --- no-reverse : no

Method used to configure the external network interface address as the NAT address of the Dialer interface
The command used to configure the external network interface address as the NAT address of the Dialer interface is as follows: [USG6600-1]nat server 1 protocol tcp global interface Dialer 0 100 inside 192.16 8.1.100 100

Whether the NAT policy can call the address group on USG firewalls
Yes. address-set indicates the address group. Configure the source IP address that requires traffic mapping. source-address { address-set address-set-name &<1-6> | ipv4-address [ ipv4-mask-length | mask mask-address ] | ipv6-address ipv6-prefix-length | range { ipv4-start-address ipv4-end-address | ipv6-start-address ipv6-end-address } | mac-address &<1-6> | any } Configure the destination IP address that requires traffic mapping. destination-address { address-set address-set-name &<1-6> | ipv4-address [ ipv4-mask-length | mask mask-address ] | ipv6-address ipv6-prefix-length | range { ipv4-start-address ipv4-end-address | ipv6-start-address ipv6-end-address } | mac-address &<1-6> | any }

Method used to change the license on USG firewalls
1. If functions controlled by a license need to be expanded or added, you need to acquire a license file again. Perform the steps for applying for a license file. The license center automatically combines the original license file and the license file for a new feature and generates a new license file. 2. If the previous license file is used on device A and it will be used on device B, seek help from the license management center, by sending the device ESN, LAC, contract No. and change information to license@huawei.com.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top