Default alarm severity on the USG6000

7

The default alarm severity on the USG6000 is Warning.

Other related questions:
How can I set alarm severity on a WLAN device
To set alarm severity on a WLAN device, run the alarm-name alarm-name severity severity command in the alarm management view. Run the undo alarm-name severity command to restore the alarm severity to the default setting.

Adjusting alarm severities of OceanStor 9000 V100R001C01
Procedure for adjusting alarm severities of OceanStor 9000 V100R001C01: 1. Log in to DeviceManager. 2. Choose Settings > Alarm Settings > Alarm Severity. 3. In the Alarm Severity drop-down list, set an alarm severity. Alarm severities include Critical, Major, Warning, and Informational. 4. Select an alarm based on site requirements, and click Enable Alarm Reporting or Disable Alarm Reporting to set whether the alarm is reported to the upper-layer network management system.

How to send information based on log severity on S series switches
For S series switches (except the S1700), run the following commands in the system view to configure an information channel to send only logs with a specified log severity: - Log: info-center source (specifies the module) channel (specifies the channel) log level (specifies the severity of output logs) - Trap: info-center source (specifies the module) channel (specifies the channel) trap level (specifies the severity of output traps) - Debug: info-center source (specifies the module) channel (specifies the channel) debug level (specifies the severity of output debug messages)

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top