Configuring the RIP priority on the firewall

15

The method for modifying the RIP priority on the USG2000&5000&6000 is as follows:

-Modifying the RIP priority:

[USG]rip
[USG-rip-1]preference 80

Other related questions:
RIP configuration of USG firewalls
Configure the RIP on the USG2000 or USG5000 as follows: 1. Run the system-view command to enter the system view. 2. Run the rip [ process-id ] command to enable the RIP route process and enter the RIP view. If the RIP commands are configured in the interface view before the RIP is enabled, the configuration only takes effect after the RIP is enabled. 3. Run the network network-address command to enable the RIP in the specified network segment. The RIP runs only at the interface in the specified network segment. For other interfaces, the RIP does not receive and send routes or does not forward the interface route. Therefore, after the RIP is enabled, you must specify the network segment. The network-address indicates the address in the natural network segment. By default, the RIP is disabled at all interfaces after it is enabled. Note: The RIP does not support different addresses specified for different RIP processes of the same physical interface. 4. By default, the interface receives RIP-1 and RIP-2 packets but sends only RIP-1 packets. When the interface version is RIP-2, you can specify the packet sending mode. If the RIP version is not configured for the interface, the global version shall prevail. Configure the global RIP version by running the version { 1 | 2 } command. Configure the RIP version for the interface. a. Run the system-view command to enter the system view. b. Run the interface interface-type interface-number command to enter the interface view. c. Run the rip version { 1 | 2 [ broadcast | multicast ] } command to specify the RIP version of the interface.

Configuring the IS-IS priority on the firewall
The method for modifying the IS-IS priority on the USG2000&5000&6000 is as follows: -Modifying the IS-IS priority: [USG]isis [USG-isis-1]preference 90

How do I change the priority of a RIP route
Because RIP packets cannot carry the preference field, the router priority is valid only for local RIP routes. To change the priority of a RIP route, run the preference { preference | route-policy route-policy-name }* command in the RIP view of the receiver. You can also apply a routing policy to set a priority for a specific route.

Configuring the BGP priority on the firewall
The method for modifying the BGP priority on the USG2000&5000&6000 is as follows: -Modifying the BGP priority: [USG]bgp 25212 [USG-bgp]ipv4-family unicast [USG-bgp-af-ipv4]preference 120

Configuring the OSPF priority on the firewall
The method for modifying the OSPF priority on the USG2000&5000&6000 is as follows: -Modifying the OSPF priority: [USG]ospf [USG-ospf-1]preference 30

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top