How does the USG allow OSPF to advertise the virtual address of VRRP?

3

In the area of ospf, use the network command to publish the virtual address.

Other related questions:
Configuring OSPF to advertise virtual IP addresses of VRRP groups on the USG
In the OSPF zone, run the network command to advertise virtual addresses.

Whether the USG6000 virtual firewall supports OSPF
No.

Whether the firewall supports the VRRP group virtual IP address and interface address that are on different network segments
Can actual interface IP addresses reside on the same network segment as virtual IP addresses in hot standby? 1. You must assign IP addresses to a physical interface before you set the virtual IP address of the VRRP group on the interface. 2. When you configure VRRP groups, ensure that the virtual IP addresses is not the IP address of any physical interface. 3. Invalid address, such as broadcast address, multicast address, or loopback address, cannot be used as the VRRP virtual IP address. 4. If the virtual IP address and the IP address of the physical interface reside on different subnets, you need to specify the subnet mask of the virtual IP address. 5. The VRID of the VRRP group cannot be the same as that configured on any other device in the same VLAN. 6. The VRIDs and virtual IP addresses of VRRP groups configured for the same interfaces on the active and standby USGs shall be the same. Configuration on the USG6000 [USG6600-1]int vlani2 [USG6600-1-Vlanif2]ip add 172.16.1.1 24 [USG6600-1-Vlanif2]vrrp vrid 1 virtual-ip 10.1.1.1 24 active [USG6600-1-Vlanif2]dis thi interface Vlanif2 ip address 172.16.1.1 255.255.255.0 vrrp vrid 1 virtual-ip 10.1.1.1 255.255.255.0 active Configuration on the USG2000&5000 [USG5500]int vlanif10 [USG5500-Vlanif10]ip add 172.16.1.1 24 [USG5500-Vlanif10]vrrp vrid 1 virtual-ip 10.10.1.1 24 master [USG5500-Vlanif10]dis this interface Vlanif10 alias vlanif 10 ip address 172.16.1.1 255.255.255.0 vrrp vrid 1 virtual-ip 10.10.1.1 255.255.255.0 master #

USG configures the ospf type
The USG2000 & 5000 & 6000 configuration type method is as follows 1. Run: system-view The system view is displayed. 2. Run: interface interface-type interface-number The interface view is displayed. 3. Run the ospf network-type {broadcast | nbma | p2mp | p2p} command to configure the network type of the OSPF interface. When the user configures a new network type for the interface, the network type of the original interface will be replaced.

Configuring OSPF to import default routes on the USG2000 series
Configure OSPF to import default routes on the USG2000 series as follows: 1. In the user view, run the system-view command to enter the system view. 2. Run the ospf [ process-id ] command to access the OSPF view. 3. Select the following configurations as required. To import a default route to the OSPF process, run the default-route-advertise [ [ always | permit ] | cost cost | type type | route-policy route-policy-name ] * command. To specify the default cost of Type-3 summary LSA, run the default-route-advertise summary cost cost command.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top