Configuring the OSPF priority on the firewall

10

The method for modifying the OSPF priority on the USG2000&5000&6000 is as follows:

-Modifying the OSPF priority:

[USG]ospf
[USG-ospf-1]preference 30

Other related questions:
Configuring the IS-IS priority on the firewall
The method for modifying the IS-IS priority on the USG2000&5000&6000 is as follows: -Modifying the IS-IS priority: [USG]isis [USG-isis-1]preference 90

Configuring the BGP priority on the firewall
The method for modifying the BGP priority on the USG2000&5000&6000 is as follows: -Modifying the BGP priority: [USG]bgp 25212 [USG-bgp]ipv4-family unicast [USG-bgp-af-ipv4]preference 120

Configuring the RIP priority on the firewall
The method for modifying the RIP priority on the USG2000&5000&6000 is as follows: -Modifying the RIP priority: [USG]rip [USG-rip-1]preference 80

Configure the priority of an OSPF route on an S series switch
The routing protocols may share and select the routing information because a switch may run multiple dynamic routing protocols simultaneously. In this case, a priority should be set for each routing protocol. When different protocols find multiple routes to the same destination, the route discovered by the protocol with a higher priority is preferred. On an S series switch, you can run the preference command in the OSPF process view to configure the OSPF priority. Perform the following operations: 1. Run the ospf [ process-id ] command in the system view to enter the OSPF process view. 2. Run the preference [ ase ] { preference | route-policy route-policy-name } * command to configure the OSPF priority. The parameters are described as follows: ase: indicates the priority of the AS-External route. preference: indicates the OSPF route priority. A smaller value indicates a higher priority. route-policy route-policy-name: indicates the priority for specified routes in the routing policy. The default OSPF priority value is 10. When an ASE is specified, the default OSPF priority is 150. For example, set the priority of routes in OSPF process 100 to 150 as follows: [HUAWEI] ospf 100 [HUAWEI-ospf-100] preference 150

Modifying the routing protocol priority on the firewall
The method for modifying the routing protocol priority on the USG2000&5000&6000 is as follows: -Modifying the static routing protocol priority: [USG]ip route-static 192.168.0.0 16 10.1.1.1 preference 20 -Modifying the RIP priority: [USG]rip [USG-rip-1]preference 80 -Modifying the OSPF priority: [USG]ospf [USG-ospf-1]preference 30 -Modifying the IS-IS priority: [USG]isis [USG-isis-1]preference 90 -Modifying the BGP priority: [USG]bgp 25212 [USG-bgp]ipv4-family unicast [USG-bgp-af-ipv4]preference 120

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top