Whether a default route is configured when the USG6000 is connected to the carrier's gateway

1

You need to configure a default route destined for the carrier's gateway address to guide data packet forwarding.

Other related questions:
Configuring OSPF to import default routes on the USG6000 series
Configure OSPF to import default routes on the USG6000 series as follows: 1. In the user view, run the system-view command to enter the system view. 2. Run the ospf [ process-id ] command to access the OSPF view. 3. Select the following configurations as required. To import a default route to the OSPF process, run the default-route-advertise [ [ always | permit ] | cost cost | type type | route-policy route-policy-name ] * command. To specify the default cost of Type-3 summary LSA, run the default-route-advertise summary cost cost command.

How to configure the default gateway on an S series switches
In the routing table, the default route is a special route with destination network 0.0.0.0 and subnet mask 0.0.0.0. If the destination IP address of a packet does not match any specific entry in the routing table, the default route is selected for packet forwarding. Generally, for low-end S series switches, a default route to the management gateway is configured. The configuration details are as follows: [Quidway]ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

AR router is configured with default routes
The AR router is configured with default routes. If the preference of a static route is not set, the default preference of the static route is 60. When both the destination IP address and mask are 0.0.0.0, the configured route is the default route. If the routing table does not have matching routes, the default route is used to forward packets.
<Huawei> system-view
[Huawei] ip route-static 0.0.0.0 0.0.0.0 172.16.0.1 //Configure the default route and specify the next hop as 172.16.0.1.<

Can external ports of the SC server be connected to the networks of China Telecom and China Unicom?
If IP addresses for common communication on public networks can be obtained, public networks can be deployed for the SC. Whether public networks can be deployed for the SC does not depend on network carriers. During SC traversal between private and public networks, one LAN port is used for connecting to a public network. Therefore, two public networks cannot be connected at the same time.

Whether the license is delivered with the USG6000 series by default
For the USG6000 series, the license must be purchased separately.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top